Practice HPE6-A75 Questions With Certification guide Q&A from Training Expert Prep4away
Free HP HPE6-A75 Test Practice Test Questions Exam Dumps
NEW QUESTION 17
When is it necessary to use an SNMP based Enforcement profile to send a VIAN?
- A. When we have to assign a VLAN to a wireless user on an Aruba Mobility Controller.
- B. When we have to assign a VLAN to a wired user on a third party wired switch that doesn't support RADIUS authentication.
- C. When we have to assign a VIAN to a wired user on an Aruba Mobility Controller.
- D. When we have to assign a VLAN to a wired user on an Aruba Mobility Access Switch.
- E. When we have to assign a vlan to a wired user on a third party wired switch that doesn't support RADIUS return attributes.
Answer: D
NEW QUESTION 18
An administrator configures an ArubaOS-Switch for per -user tunneled node. Which protocols does the switch use to establish and maintain a connection with the Aruba Mobility Controller (MO? (Select two.)
- A. SSL
- B. GRE
- C. PAPI
- D. IPSec
Answer: B,C
NEW QUESTION 19
Refer to the exhibit.
An employee connects a corporate laptop to the network and authenticates for the first time using EAP-TLS. Based on the Enforcement Policy configuration shown, which Enforcement Profile wilt be sent?
- A. Onboard Pre-Provisioning - Aruba
- B. Deny Access Profile
- C. Onboard Post-Provisioning - Aruba
- D. Onboard Device Repository
Answer: A
NEW QUESTION 20
Which protocol do Mobility Controllers (MCs) use to detect a failed Mobility Master (MM)?
- A. SNMP
- B. VRRP
- C. IPSec
- D. PAPI
Answer: A
NEW QUESTION 21
Refer to the exhibit.
A known unicast packet is received from Switch-1 on the standby and must be forwarded to Switch-2. How does the VSF fabric decide which port in the aggregated (ink should forward the packet?
- A. The standby sends the packet to the commander over a VSF link, and the commander decides the correct port.
- B. The standby selects the port on the designated forwarder for the aggregation.
- C. The standby uses the typical load sharing algorithm, and it might select either its port or the commander's port.
- D. The standby uses its own port in the link aggregation to forward the fabric.
Answer: D
NEW QUESTION 22
in a VPN that uses certificate-based authentication, which component must be configured on the Mobility Master (MM) to allow a RAP to successfully connect to a Mobility Controller (MC)
- A. RAP IPSec pre-shared key
- B. RAP whitelist
- C. RAP VPN username and password
- D. WLAN and new RAP group
Answer: B
NEW QUESTION 23
What is true about clustering and AP connections to cluster members?
- A. During rebalancing, the active load is redistributed first.
- B. The default thresholds are 75% for the Rebalanced Threshold and 25% for the Unbalanced Threshold.
- C. AP load balancing is disabled by default.
- D. The AP will always stay connected to the LMS IP address configured in the AP profile.
Answer: C
NEW QUESTION 24
Refer to the exhibit.
Which statements accurately describe the status of the Onboarded devices in the configuration tor the network settings shown? (Select two.)
- A. They will connect to Employee_Secure SSID for provisioning their devices.
- B. They will use WPA2-PSK with AES when connecting to the SSID.
- C. They will connect to Employee_Secure SSID after provisioning.
- D. They will perform 802.1X authentication when connecting to the SSID.
- E. They will connect to secure_emp SSID after provisioning.
Answer: D,E
NEW QUESTION 25
A company requires AOS-Switches at the campus core. The switches:
Will act as the default gateways for several campus VLANs
Must provide redundancy for their services and tolerate the loss of a link or an entire switch Must recover from the failure of one of the switches within a second or less VRRP and MSTP are proposed to meet these requirements. What is an issue with this proposal?
- A. VRRP does not interoperate with MSTP.
- B. VRRP provides redundancy against lost links but not a failed switch.
- C. VRRP provides routing redundancy but not default gateway redundancy.
- D. VRRP takes longer than a second to fail over.
Answer: D
NEW QUESTION 26
Refer to the exhibit.
When configuring a Web Login Page in ClearPass Guest, the information shown is displayed. What is the Address field value 'securelogin.arubanetworks.com' used for?
- A. for ClearPass to send a RADIUS request to the NAD
- B. for the client to POST the user credentials to the NAD
- C. for appending to the Web Login URL, before the page name
- D. for appending to the Web Login URL, after the page name.
- E. for ClearPass to send a TACACS+ request to the NAD
Answer: B
NEW QUESTION 27
An administrator supports a cluster of four Aruba Mobility Controllers (MCs) with management addresses of 10.1.100.101, 10.1.100.102, 10.1.100.103, and 10.1.202.181. The administrator accesses an AP associated with this cluster, reboots it and accesses apboot mode. The administrator executes the printenv command. Which AP parameter contains the IP addresses of the cluster members that the AP should use to connect to the cluster?
- A. Noodelist
- B. Master_ip
- C. Servername
- D. Cfg_lms
Answer: A
NEW QUESTION 28
What is the purpose of the captive portal URL hash key on an AOS-Switch?
- A. It encrypts and secures the RADIUS messages that the AOS-Switch sends to ClearPass.
- B. It specifies the captive portal URL and conceals the setting in the config.
- C. It does not let users alter the URL that redirects them to the portal.
- D. It authenticates guest users based on the password the users enter hi the portal.
Answer: C
NEW QUESTION 29
Refer to the exhibit.
An AD user's department attribute is configured as *HR". The user connects on Monday using their Windows Laptop to a switch that belongs to the Device Group HQ. Which role is assigned to the user in ClearPass?
- A. iOS Device
- B. Remote Employee
- C. Executive
- D. Vendor
- E. HR Local
Answer: B,E
NEW QUESTION 30
A customer wants to implement Virtual IP redundancy, such that in case of a ClearPass server outage, 802.1x authentications will not be interrupted. The administrator has enabled a single Virtual IP address on two ClearPass servers.
Which statements accurately describe next steps? (Select two.)
- A. The NAD should be configured with the primary node IP address for RADIUS authentication on the 802.1x network.
- B. The NAD should be configured with the Virtual IP address for RADIUS authentications on the 802.1x network.
- C. The primary node will respond to authentication requests sent to the Virtual IP address when the primary node is active.
- D. A new Virtual IP address should be created for each NAD.
- E. Both the primary and secondary nodes will respond to authentication requests sent to the Virtual IP address when the primary node is active.
Answer: B,C
NEW QUESTION 31
An administrator wants to use Airwave to manually add devices on the network. Where should the administrator perform this action?
- A. in AMP Setup
- B. in Devices
- C. in Device Setup
- D. in Groups
Answer: C
NEW QUESTION 32
Which statement is true about the databases in ClearPass?
- A. Entries in the local user database cannot be modified.
- B. A Static host list can only contain a list of IP addresses.
- C. The endpoints database can only be populated by manually adding MAC addresses to the table.
- D. Entries in the guest user database can be deleted.
- E. Entries in the guest user database do not expire.
Answer: E
NEW QUESTION 33
Refer to the exhibit.
Based on the Enforcement Policy configuration, when a user with Role Engineer connects to the network and the posture token assigned is Unknown, which Enforcement Profile will be applied?
- A. Deny Access Profile
- B. RestrictedACL
- C. HR VLAN
- D. Remote Employee ACL
- E. EMPLOYEE_VLAN
Answer: A
NEW QUESTION 34
A network administrator configures V5F settings on two Aruba 2930F switches. The switches form two separate VSF fabrics. What should the administrator check?
- A. that the switch with the lower priority has the lower member ID
- B. that each switch is assigned a unique VSF priority
- C. that the domain ID matches on both switches
- D. that LLDP MAD is configured on both members
Answer: A
NEW QUESTION 35
What must an OSPF router do when it receives a link state update?
- A. It must participate in a new election for the Designated Router and Backup DR.
- B. It must run the shortest path first algorithm.
- C. It must re-establish adjacency with its Designated Router and Backup DR.
- D. It must initiate a graceful restart timer.
Answer: B
NEW QUESTION 36
What are Operator Profiles used for?
- A. to assign ClearPass roles to guest users
- B. to enforce role based access control for Aruba Controllers
- C. to enforce role based access control for ClearPass Guest Admin users
- D. to map AD attributes to admin privilege levels in ClearPass Guest
- E. to enforce role based access control for ClearPass Policy Manager admin users
Answer: C
NEW QUESTION 37
An administrator mistakenly configures the wrong VLAN setting on a managed controller's interface. This causes the controller to lose management access to the Mobility Master (MM).
Which mechanism will then attempt to restore the previous working configuration on the managed controller?
- A. bulk configuration
- B. disaster recovery
- C. restore config
- D. auto-rollback
Answer: D
NEW QUESTION 38
......
Prepare Top HP HPE6-A75 Exam Audio Study Guide Practice Questions Edition: https://pass4sure.troytecdumps.com/HPE6-A75-troytec-exam-dumps.html